May Release 2025

Our May Release 2025 comes with some new features that some of you have requested and will make your life in the measurement and trimming proccess even easier than it was before. We hope you are as excited to check them out as we are! 

Share your simulation with friends and get their feedback

You are in the simulation and unsure if the loops that you have selected are good? You can now save and share them with friends and even get direct feedback from them via the ­ button. Your drafts as well as suggestions from friends will appear as "draft" in the measurement overview of your wing. 

Improved organization of measurement start with better import features

We have now improved how the measurement start is organized to make everything more tidy and clear to you.

You can for example now select, if you would like to measure or import a measurement directly before starting the measurement.

 

Editing certain setting of your measurement in every step

In the past, when you selected a loop incorrectly before starting the measurement, the simulation didn't work well anymore.

Or you have selected that you'd like to measure your brakes but during measurement find it to exhausting. In the measurement screen via the the ­ button.

button you can now select or unselect if you want to measure the brakes. 

And you now have the possibility to change the initial setup of your loops during simulation via the ­ button.

Compare public measurements of the same wing model with your own measurement results

When you look at public measurements you can compare them to your own measurements by clicking the comparison button ­ .

Data integrity improvements

You will get direct optical feedback on the integrity of your data. Are they imported? Certain values manually changed? Or have they been recorded with the help of a connected laser? All this will be displayed immediately with colored dots for each measurement point. 

Buy us coffee